This is Aleksandr Strizhakov dream bike. He wanted to make a replica of the new aged 2018-19 CRF250 with a CR125 engine. He has been in the works of this build from early 2017. We featured his bike on MXA back in September when it was in the works. It is worth a look to see the start of the build. Another nine months have past and Aleksandr sent us an email about his story and photos of his 2019 Honda CR125 build. Take notes Honda, or Russia is going to build them for you. Take it away Aleksandr:
“The construction of the bike of my dreams was somewhat delayed, but it has finally come to fruition. I am an engineer and a designer that really loves motocross. I like the handling in the frame of the third generation Honda CR125, and I decided to put it in the hull of Honda’s new design body. It was an excellent and interesting job. I hand built the subframe and transmission and carbon air box. Since I needed a new fuel tank, I decided to make it out of titanium. I applied my method of hydroforming the sides of the tank using a hand grease pump. Next, I worked with metal sheet and after that the entire tank was TIG welded by a friend and the best welder Vladimir. This is the titanium gas tank that can be seen on my bike! I am a perfectionist and decided to build a motorcycle from the best parts in the world, and many parts are made by me. The bike was very light and handling amazing. It has powerfull Motostuff front motor Powerful brakes motostuff rotor well that is controlled be an RE caliper. Of course the engine is inferior to the engines of the KTM and Husky and even Yamaha. But I am 55 years old and the engine suits my riding capability perfect. I also used a hydraulic clutch to help the engine (the bad news is that did honda not make the hydraulic clutch on the 2019 model)! But I can install any two-stroke engine in this frame. Here is a list of details and work:
Chassis: 2004 Honda CR125 frame and swingarm. Honda 2017 plastics and seat (I installed the front wing of the 2016 model, which is more suitable for a light 125). D.I.D. LTX rims that I lightened and powder coated the hubs
Suspension: 46mm Öhlins front forks that have titanium nitrided lower tubes. Emig modified and polished triple clamps. KYB KXF250 rear shock (shorter than the Honda at 6mm, which lowered the rear of the bike)
The 2004 Honda CR125 engine.
Engine: 2004 Honda CR125 is that used a Wiseco piston, V-force valve, Pro Circuit pipe and carbon-titanium silencer, Barnett clutch basket and pressure plate and powder coated the right side engine for works factory look. AJP hydraulic clutch master and main cylinder.
Brakes: Motostuff 270mm front rotor and Ride Engineering caliper (hand modified and polished for works factory view) Used the stock rear caliper that I vented the body by drilling and used a titanium piston and BBR pedal/ titanium LS footpegs
Hand made: Titanium thickness 0.8mm gas tank. Aluminum subframe. Carbon fiber air box. Full complete titanium bolts.Titanium front/ rear axle and swingarm pivot bolts. Titanium footpegs bracket and more titanium small parts
Aleksandr Strizhakov. Russia. Sankt-Petersburg
The post TWO-STROKE TUESDAY | 2019 HONDA CR125 BUILT IN RUSSIA appeared first on Motocross Action Magazine.